Kohler K-1151 주택 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Kohler K-1151에 대한 주택 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1151 29 페이지. Bath with airjets
Kohler K-1151에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (36 페이지), 주택 소유자 매뉴얼 (32 페이지), 설치 매뉴얼 (48 페이지), 주택 소유자 매뉴얼 (36 페이지), 설치 매뉴얼 (36 페이지), 러프인 매뉴얼 (4 페이지), 설치 매뉴얼 (48 페이지), 주택 소유자 매뉴얼 (29 페이지)

Purge Mode

Your Kohler Bath with Airjets

Components

Your new bath with airjets is designed to stimulate, invigorate, and energize your body with soothing

massage therapy. It can also provide a gentle relaxing massage when operated at a lower speed.

• Bath - Allows the bather to relax in comfort while enjoying the air massage.

• Blower Motor - Provides quiet power to supply air for a soothing massage action.

• Airjets - Distributes and releases the air at the lower edge of the bath side and end walls for a

soothing massage action.

• User Keypad - Located within easy reach, the user keypad turns the unit on and off, controls the air

ﬂow rate, and controls the manual purge mode.

User Keypad

On/Off - Turns the blower motor on or off. Press the button once to start the blower motor at a

mid-range speed. Press the button again to stop the blower motor. The blower motor automatically

stops after about 20 minutes of operation.

NOTE: An automatic purge cycle will initiate approximately 30 minutes after the blower motor has

stopped. To activate the purge cycle sooner, manually initiate the purge mode.

Purge Mode - Initiates a manual purge cycle, which will blow any residual water out of the air

channels after the bath has been drained. Press the button once to start the blower motor at low

speed. The blower motor stops automatically after about two minutes. Press the button again before

the cycle ends to stop the blower motor.

Up Arrow - Increases the air ﬂow.

Down Arrow - Decreases the air ﬂow.

Operation

Close the drain, then ﬁll the bath to a level at least 4" (10 cm) above the top of the highest airjets.

Use your hand to test the water temperature for comfort and safety, then carefully enter the basin.

Press the On/Off button to turn on the blower motor.

NOTE: For baths equipped with an optional timer: Approximately 20 minutes of continuous operation,

the blower motor will stop. If desired, press the On/Off button to restart the blower motor.

If desired, press the up or down arrow buttons to change the air ﬂow rate.

When ﬁnished bathing, press the power button a second time to turn off the blower motor.

Carefully exit the bath, then open the drain to empty the bath.

1034591-5-K

On/Off

Increases Flow

Decreases Flow

Kohler Co.