Kohler K-1164 설치 매뉴얼 - 페이지 12

{카테고리_이름} Kohler K-1164에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1164 48 페이지. Bath with airjets
Kohler K-1164에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (32 페이지), 주택 소유자 매뉴얼 (29 페이지), 주택 소유자 매뉴얼 (36 페이지), 러프인 매뉴얼 (4 페이지), 설치 매뉴얼 (44 페이지), 설치 및 관리 매뉴얼 (21 페이지), 주택 소유자 매뉴얼 (29 페이지)

Purge Mode

10. Conﬁrm Proper Operation

NOTICE: Ensure that the area around the blower motor is free of sawdust, insulation, dirt, or other small

loose debris. Such material could clog the blower motor air ducts and reduce the air ﬂow through the

blower motor.

NOTE: Please read these steps carefully before you operate your bath with airjets. Troubleshoot any

problems using the "Troubleshooting" section.

Keypad Operation

On/Off - Turns the blower motor on and off. Pressing the switch once starts the blower motor at a

midrange speed. Pressing the button again stops the blower motor. The blower motor automatically

stops after about 20 minutes of operation. The blower motor can be restarted by pressing the

On/Off button.

Purge Mode - Initiates the purge cycle manually. The purge cycle blows any residual water out of

the air channels after the bath has been drained. Pressing the button once starts the blower motor at

low-speed. The blower motor stops automatically after about two minutes. Pressing the button

again before the cycle ends will stop the blower motor. Note that this product also has an automatic

purge cycle, which initiates about 30 minutes after the blower has stopped.

Increases Flow - Increases the air ﬂow.

Decreases Flow- Decreases the air ﬂow.

Preliminary Checks

Temporarily remove all access panels.

Verify that the union connection at the check valve is securely hand tightened.

Verify that the screws are installed in the PVC air piping at the blower motor and at the check

valve.

Verify that cable ties support the air piping.

Verify that the blower motor is secure.

Verify that the keypad cable is securely connected at the user keypad and at the blower motor.

Fill the bath to a level at least 2" (5 cm) above the top of the highest airjet.

Conﬁrm Air System Operation

1034591-2-F

On/Off

Increases Flow

Decreases Flow

Kohler Co.