Kohler System II K-809 설치 매뉴얼 - 페이지 4

{카테고리_이름} Kohler System II K-809에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler System II K-809 28 페이지. Drop-in bath whirpool

Construct 2x4 or 2x6

stud framing according

to the roughing-in

information

1. Prepare the Site

NOTICE: Unless otherwise specified, floor support under the whirlpool must provide for a minimum of 80

lbs./square foot (390 Kg./square meter) loading.

NOTICE: Do not support the whirlpool by the rim.

- Make sure the flooring offers adequate support for your whirlpool, and verify that the subfloor is flat and level.

- The whirlpool should be installed in a drop in installation. Construct 2x4 or 2x6 stud framing designed for your

particular installation. Provide a 1/16" (2mm) gap between the whirlpool rim and the stud framing. Frame the

floor, or construct a frame for a raised installation in accordance with the roughing in information packed with

the whirlpool.

- Use the roughing in cut out information to carefully lay out and cut the rough deck material.

- Position the plumbing according to the roughing in information packed. Cap the supplies, and check for leaks.

- Install the drain to the whirlpool according to the drain manufacturer's instructions. Do not connect the trap at

this time.

- Position a clean drop cloth or similar material in the bottom of the whirlpool. Be careful not to scratch the surface

of the product.

1011606-2-

Position

the rough

plumbing

Provide a 1/16" (2mm) gap

between the whirlpool rim

and the framing

Frame the floor

according to the

roughing-in

information

Verify that the subfloor

offers adequate support,

and is flat and level

Kohler Co.