Kohler EIR K-77800T-0 설치 매뉴얼 - 페이지 7

{카테고리_이름} Kohler EIR K-77800T-0에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler EIR K-77800T-0 43 페이지. Eir intelligent toilet (wt2,hs) p trap, eir intelligent toilet (wt2,hs) p trapex
Kohler EIR K-77800T-0에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (44 페이지)

페이지 인쇄

Place an 800mmX800mm cushion on the floor, take the toilet out from the carton then place on cushion.

Floor Water Outlet Installation

A. Remove Existing Toilet (If any)

Turn off the water supply. Flush the toilet, and use a sponge to remove the remaining water from the tank and bowl.

Disconnect water supply shut-off valve (if any), and remove the residual tank and bowl.

Remove old gasket from the floor and toilet flange accessory bag with a putty knife. Dismantle residual T-bolts and

discard them.

NOTICE: if a new toilet is not installed immediately, temporarily stuff a rag in flange accessory bag.

B. Roughing-in

DANGER: Risk of electric shock. Disconnect power supply before servicing.

NOTE: This product is designed to work with wall mounted electrical and water supplies as shown in the

mounting dimensions.

WARNING: Risk of electric shock. Connect only to circuits protected by Ground-Fault Circuit-Interrupters (GFCI's)

or Earth-Leakage Circuit-Breakers (ELCB's).

Keep bath and shower head away from electrical parts (such as remote controller, receptacle etc). When the

electrical supply is mounted on the wall, an anti-splash and waterproof receptacle is required.

Kohler Co.

Fig.#6

Flange accessory package

Fig.#7

1357244-T01-E