Kohler EIR K-77800T-0 주택 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Kohler EIR K-77800T-0에 대한 주택 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler EIR K-77800T-0 44 페이지. Eir intelligent toilet (wt2,hs) p trap, eir intelligent toilet (wt2,hs) p trapex
Kohler EIR K-77800T-0에 대해서도 마찬가지입니다: 설치 매뉴얼 (43 페이지)

페이지 인쇄

Auxiliary keyboard function

UV radiation range

Note:

1. Each function performance shall conform to factory setting.

2. When use the front wash/rear wash mode, activate corresponding function, auto deactivate after 5min.

Deactivate front wash/rear wash/dryer function by pressing "

Use "

" button to flush bowl.

Wide oscillate clean function

The Bidet is equipped with wide oscillate clean function. If you would like to use wide oscillate function, push

and hold rear wash + STOP button about 2s before activate rear wash + oscillate function; activate oscillate

function.

Standby mode

1. Push and hold "

detection and remote function deactivated at this point, so as IoT function (for IoT models), top indicating

LED OFF. Seat heating function deactivated to minimize energy consumption.

2. When press any button on side panel or seated, auto exit standby mode, all function recovered.

1357243-T01-H

B. Press button to enter

rear wash

A. Press button to

enter front wash

C. Light sensor area

Bidet nozzle

" button (over 2s) on side panel, enter standby mode when generate one "beep". Auto

D. Press button to stop all functions.

F. When unseated, push and hold rear or front wash

button until nozzle extension, perform manual clean

for nozzle, press "

" button to deactivate manual

clean function.

"button.

E. Press to perform flush full, push

and hold "

emergency flush mode when

power is off.

D 1. Standby mode

Push and hold (more than 2s) "

standby mode, details are shown in Page 14 "standby

mode" item.

2. Stop function

Press "

" button to stop flush, dryer, air purification,

One button sterilization function, manual nozzle clean

and UV function.

" for 2s to enter

" button to enter

Kohler Co.