Kohler FAMILY CARE K-23188T-S 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} Kohler FAMILY CARE K-23188T-S에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler FAMILY CARE K-23188T-S 10 페이지. 3.0/4.8l vitreous china one piece toilet s-trap 305/400mm

페이지 인쇄

QUICK REMOVAL AND INSTALLATION

(For K-23188T-ITNS/K-23189T-ITNS)

Quick Removal

Turn off water supply. Squeeze downward the blue part on

the fill valve base with one hand or non-sharp tools and

remove the fill valve by lifting it with the other hand. See

Fig.26.

Quick Installation

Squeeze downward the blue part on the fill valve base with

one hand or non-sharp tools to make sure it is ready for

assembly. See Fig.27. Confirm the direction of the float

canister and then insert the fill valve into the valve base until

it cannot be pushed any further with a 'clicking' sound. See

Fig.24. Turn on water supply and flush several times to check

for leakage.

SYMPTOMS

1. Poor Flush

2. No Flush

3. The fill valve turns on/off by itself

without the toilet being flushed, or it

runs allowing water to enter the tank.

4. Tank takes excessive time to fill.

5. There is excessive noise when the

tank is filling.

IMPORTANT: Use only genuine Kohler parts as shown to avoid property damage.

1392769-T01-C

Fig.#26

Not Ready

Ready For

For Assemble

Assemble

Fig.#27

CORRECTIVE ACTION

A. Adjust the tank water level to match the waterline.

B. Fully open the water supply shut-off valve.

C. Clear obstructions from the trapway, jet, or bowl rim holes.

D. Clear obstructions from the waste line.

A. Reconnect the chain to the trip lever or flush valve.

B. Adjust the chain assembly to remove excessive slack.

A. Adjust the chain for proper slack so the seal is not held off the flush valve seat.

B. Clean or replace the seal if it is worn, dirty, or misaligned with the flush valve seat, or

if the flush valve seat is damaged. Replace the flush valve seal or flush valve.

C. Clean the fill valve seat/seat washer of debris, or replace the piston/seat washer

assembly.

D. Remove the tank and tighten the flush valve nut if flush valve gasket is leaking. Do

not overtighten. If leakage continues, replace the gasket.

E. Adjust the tank water level if it is too high.

A. Fully open the water supply shut-off valve.

B. Clean the valve inlet, valve head, or supply line. Flush the lines.

A. Partially close the water supply shut-off valve if the water pressure to the toilet is too

high. Check the toilet performance following any such adjustment.

B. Remove dirt or obstructions from the valve head. Flush the lines.

-9-

(

K-23188T-ITNS/K-23189T-ITNS)

Fill Valve

Valve Base