Kohler HARKEN K-20825T-S 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Kohler HARKEN K-20825T-S에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler HARKEN K-20825T-S 6 페이지. 1pc toilet

페이지 인쇄

Finished Wall

400

INSTALLATION

TO REMOVE EXISTING TOILET

Turn off the water supply. Flush the toilet, and use a sponge

to remove the remaining water from the tank and bowl.

Disconnect the supply shut-off valve (if present), and remove

the old tank and bowl.

Remove the old gasket from the floor

and the closet flange with a putty knife.

Remove the old T-bolts and discard

them.

NOTICE:

if the new toilet is not

installed immediately, temporarily stuff

a rag into the closet flange.

NOTICE: Do not use white cement or high lime content

cements to install this toilet. The expansion of cement due to

a rise in temperature may make the toilet crack or cause

damage. Kohler is not responsible for any damage caused by

installation with the use of cement.

TO INSTALL SUPPLY

SHUT-OFF VALVE

Install the supply shut-off valve so it is

200mm above the finished floor line,

and 160mm to the left of the closet

flange centerline.

The centerline of the supply shut-off

valve outlet should extend 67mm from

the finished wall. Install the supply

shut-off valve with the outlet vertical.

1398171-T01-B

732

OF OUTLET

Kohler reserves the right to change marked dimensions without prior notice.

200

305/400

K-20825T

363

Supply

432

395

160

Fig.#1

Fig.#2

Closet Flange

Supply Shut-Off Valve

160

Closet Flange

Centerline

Fig.#3

-3-

FRONT OF BOWL

681

(

)

200mm

160

386

67mm;