Kohler K-11474 주택 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Kohler K-11474에 대한 주택 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-11474 32 페이지.

페이지 인쇄

Troubleshooting

This troubleshooting guide is for general aid only.

See the label on the inside of the toilet lid for service parts. Refer to the

illustration on the last page for parts identification.

Symptoms

Poor flush.

No flush.

Fill valve turns

on / off by itself

without toilet

being flushed,

or runs allow-

ing water to

enter tank.

Long tank fill

cycle.

Noisy tank fill

cycle.

Trip arm strikes

tank lid under-

side.

1042175-X5-B

• Adjust tank water level to match waterline.

• Fully open water supply shut-off valve.

• Clear obstruction in trapway, jet, or bowl rim holes.

• Clear obstruction in soil pipe or vent pipe.

• Reconnect flush ball chain to trip lever or flush valve.

• Adjust flush ball chain assembly to remove excessive slack.

• Adjust flush ball chain for proper slack so flush ball isn't held

off flush valve seat.

• Clean or replace flush ball if flush ball is worn, dirty, or

misaligned with flush valve seat or flush valve seat is

damaged Replace flush valve seal or flush valve.

• Remove tank and tighten flush valve nut if flush valve

gasket is leaking. Do not overtighten. If leakage continues,

replace gasket.

• Clean fill valve seat / seat washer of debris, or replace piston/

seat washer assembly.

• Replace fill valve if valve float sinks.

• Adjust tank water level if too high.

• Fully open water supply shut-off valve.

• Clean fill valve inlet, valve head, or supply line. Flush lines.

• Partially close water supply shut-off valve if water pressure

to toilet is too high. Check toilet performance following any

such adjustment.

• Remove dirt or obstruction in valve head. Flush lines.

• Adjust flush ball chain assembly to remove excessive slack.

• Adjust trip arm bracket and flange so they are parallel with

tank top.

Corrective action

Kohler Co.