Kohler WELLWORTH LITE K-4512 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Kohler WELLWORTH LITE K-4512에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler WELLWORTH LITE K-4512 8 페이지. Vitreous china reverse trap toilets

페이지 인쇄

TO INSTALL NEW TOILET

Place new toilet upside down on padding. Firmly place

gasket on toilet outlet.

NOTE: If using gasket with integral plastic sleeve, make

sure the gasket is positioned facing away from the toilet.

Remove rag from closet flange before setting toilet.

Carefully align and lower toilet over the closet flange and

bolts.

CAUTION: Do not lift or rock toilet after placement;

a new gasket must be reapplied if you break the

watertight seal.

Apply full body weight to toilet rim to set seal.

Assemble bolt cap bases, washers, and nuts on exposed

T-bolts. Hand-tighten nuts, then tighten additional 1/2-turn

with wrench.

CAUTION: Overtightening may cause breakage

or chipping.

If T-bolts extend more than 1/4" from top of nut, cut off ex-

cess. Wipe away any residue. Install bolt caps.

TO INSTALL NEW TANK

Make sure the three tank bolts extend fully through the

holes in the gasket. Set the tank onto the bowl using the

bolts as a guide. Center the gasket on the inlet of the bowl.

Assemble the washers and brass hex nuts onto the bolts.

CAUTION: Overtightening may cause breakage

or chipping.

Alternately tighten the three brass hex nuts so that the top

of the tank is level with the top of the bowl and a watertight

seal is obtained.

111864-2-

(-)

Toilet Outlet

Gasket

Bolt Cap

Nut

Washer

Bolt Cap Base

Tank Bolt

Washer

Nut

Fig. #5

Fig. #6

Gasket

Fig. #7

Kohler Co., Kohler, WI