Kohler Wellworth Pressure Lite K-3519-RA 주택 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Kohler Wellworth Pressure Lite K-3519-RA에 대한 주택 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Wellworth Pressure Lite K-3519-RA 45 페이지.

Gap Clearance

If the toilet does not activate, the gap between the actuator and

the plunger arm may need to be reset. Make sure the trip lever

handle is installed, and the trip lever nut is tight. This is a

left-hand thread; turn counterclockwise to tighten.

Make sure the water supply is on, and the supply line water has

stopped ﬂowing into the toilet.

Loosen the setscrew. Turn the actuator until there is a 1/16" (2

mm) - 1/8" (3 mm) gap between the actuator and the plunger

arm. Turn the actuator clockwise to increase the gap.

Tighten the setscrew after the gap is properly adjusted.

NOTE: Loss of gap clearance adjustment could cause leakage into

the toilet bowl due to the plunger not sealing properly. This

condition could cause a continual ﬂow of water. If the problem is

not corrected after adjustment, refer to the Troubleshooting section.

1054184-5-A

1/16" (2 mm) –

1/8" (3 mm) Gap

Setscrew

Plunger Arm

Actuator

Kohler Co.