Kohler COMMAND 25 HP 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Kohler COMMAND 25 HP에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler COMMAND 25 HP 21 페이지. Lp gas fueled or dual-fueled horizontal crankshaft

페이지 인쇄

Oil SentryTM

Some engines are equipped with an optional Oil

Sentry'" oil pressure switch. If the oil pressure

decreases below an acceptable level, the Oil Sentry'"

will either shut off the engine or activate a warning

signal, depending on the application.

NOTE: Make sure the oil level is checked BEFORE

EACH USE and is maintained up to the " F

mark on the dipstick. This includes engines

equipped with Oil Sentry'".

Change Oil and Oil Filter

Change Oil

Change oil after every 700 hours of operation. Refill

with service class SG, SH, SJ or higher oil as specified

in the "Viscosity Grades" table (Figure 2) on page 4.

Change the oil while the engine is still warm. The oil

will flow more freely and carry away more impurities.

Make sure the engine is level when filling, checking,

and changing the oil.

Change the oil as follows (see Figure

7):

To keep dirt, debris, etc., out of the engine, clean

the area around the oil fill cap/dipstick before

removing it.

Remove one of the oil drain plugs, oil fill cap, and

dipstick. Be sure to allow ample time for complete

drainage.

3. Reinstall the drain plug. Make sure it is tightened

7 3 . 6

N.m

( 7 0

ft. lb.) torque.

4. Fill the crankcase, with new oil of the proper type,

to the "F' mark on the dipstick. Refer to "Oil Type"

on page 4. Always check the level with the dipstick

before adding more oil.

Reinstall the oil fill cap and tighten securely.

Reinstall dipstick.

NOTE: To prevent extensive engine wear or

damage, always maintain the proper oil

level in the crankcase. Never operate the

engine with the oil level below the "L"

mark or over the "F' mark on the dipstick.

Engine Oil Drain Plug'

Figure

Oil Drain Plug and Oil Filter.

Change Oil Filter

Replace the oil filter at least every other oil change

(every 200 hours of operation). Always use a

genuine Kohler oil filter, Part No.

12 050

OI-S.

Replace the oil filter as follows:

Drain the oil from the engine crankcase by

removing one of the drain plugs and allowing

ample time for complete drainage.

Before removing the oil filter, clean the area

around the oil filter to keep dirt and debris out of

the engine. Remove the old filter. Wipe off the

surface where the oil filter mounts.

3. Place a new replacement filter in a shallow pan

with the open end up. Pour new oil of the proper

type in through the threaded center hole. Stop

pouring when the oil reaches the bottom of the

threads. Allow a minute or two for the oil to be

absorbed by the filter material.

Put a drop of oil on your fingertip and wipe it on

the rubber gasket.

Install the new oil filter onto the filter adapter. Turn

the oil filter clockwise until the rubber gasket

contacts the mounting surface, then tighten the

filter an additional

2 / 3

to 7 turn.

6. Reinstall the drain plug. Make sure it is tightened

7 3 . 6

N.m

( 7 0

ft. lb.) torque.

Fill the crankcase with new oil of the proper type

to the " F mark on the dipstick.