Kohler Command PRO CH23 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Kohler Command PRO CH23에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Command PRO CH23 10 페이지. Vertical/horizontal crankshaft
Kohler Command PRO CH23에 대해서도 마찬가지입니다: 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (8 페이지), 소유자 매뉴얼 (24 페이지)

페이지 인쇄

Maintenance lnstructions

AwARNING

Before working on engine or equipment, disable

Accidental Starts can cause

engine as follows: 1) Disconnect spark plug

severe injury or death.

lead(s). 2) Disconnect negative(-) battery cable

. Disconnect and ground spark

from battery .

plug lead(s) before servicing.

Normal maintenance, replacement:onepair of emission control devices and systems may be

rierformed by any repair establishment or individual; however, warranty repairs must be performed

1y a Kahler authorized dealer found at KohlerEngines.com or

1-800-544-2444

(U.S. and Canada).

• Replace low-profile air cleaner element.

• Change oil.

• Remove cooling shrouds and clean cooling areas.

• Chec!< oil cooler fins, cle~n as necessary (if equipped).

• Have crankshaft spline lubricated.

Perform these procedures more frequently under severe, dusty, dirty conditions.

Have a Kahler authorized dealet perform this service.

Recommendat,ons

••re recommend use of Kahler oils for best

3rformance. Other high-quality detergent

uds (including synthetic) of API (American

Petroleum Institute) service class SJ or higher

·e acceptable. Select viscosity based on air

mperature at time of operation as shown in

table below.

Check Oll Level

NOTE: . To prevent extensive engine wear or

damage, never run engine with oil level

below or above operating range

indicator on dipstick.

Ensure engine is cool. Clean oil fill/dipstick

areas of any debris.

Remove dipstick; wipe oil off.

a. Press-in cap: reinsert dipstick into tube;

press completely down.

b. Thread-on cap: reinsert dipstick into

tube; rest cap on tube, do not thread cap

onto tube.

2. Remove dipstick; check oil level. Level

should be at top of indicator on dipstick.

3. lf oil is low on indicator, add oil up to top of

indicator mark.

4. Reinstall dipstick and tighten securely.