Kohler Command Pro CV1000 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Kohler Command Pro CV1000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Command Pro CV1000 21 페이지. Vertical
Kohler Command Pro CV1000에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

Paper Element

Figure 21. Removing Elements.

3. After the paper element is removed, check the

condition of the inner element. It should be

replaced whenever it appears dirty, typically

every other time the main element is replaced or

every 600 hours. Clean the area around the base

of the inner element before removing it, so dirt

does not get into the engine.

4. Do not wash the paper element and inner

element or use compressed air, this will damage

the elements. Replace dirty, bent or damaged

elements with new genuine Kohler elements as

required. Handle the new elements carefully; do

not use if the sealing surfaces are bent or

damaged.

5. Check all parts for wear, cracks, or damage, and

make sure ejector area is clean. See Figure 22.

Replace any damaged components.

Figure 22. Ejector Area.

6. Install the new inner element, Kohler Part No.

25 083 04-S followed by the paper element,

Kohler Part No. 25 083 01-S. Slide each fully into

place in the air cleaner housing.

7. Reinstall the end caps and secure with the

retaining clips. See Figure 19.

Inner Element

Ejector

Area

Clean Air Intake/Cooling Areas

To ensure proper cooling, make sure the grass screen,

cooling fins, and other external surfaces of the engine

are kept clean at all times.

NOTE: Operating the engine with a blocked grass

screen, dirty or plugged cooling fins, and/or

cooling shrouds removed, will cause engine

damage due to overheating.

Ignition System

An electronic Capacitive Discharge (CD) ignition

system is used. Other than periodically checking/

replacing the spark plugs, no maintenance, timing, or

adjustments are necessary or possible with this

system.

Check Spark Plugs

Every 200 hours of operation, remove the spark plugs,

check condition, and reset the gap. Replace with new

plugs every 600 hours, or as necessary. The standard

spark plug is a Champion

62 132 04-S). Equivalent alternate brand plugs can

also be used.

1. Before removing the spark plug, clean the area

around the base of the plug to keep dirt and

debris out of the engine.

2. Remove the plug and check its condition. Replace

the plug if worn or reuse is questionable.

NOTE: Do not clean the spark plug in a machine

using abrasive grit. Some grit could remain

in the spark plug and enter the engine

causing extensive wear and damage.

3. Check the gap using a wire feeler gauge. Adjust

the gap to 0.76 mm (0.030 in.) by carefully

bending the ground electrode. See Figure 23.

Wire Gauge

Spark Plug

Ground

Electrode

Figure 23. Servicing Spark Plug.

XC10YC (Kohler Part No.

0.76 mm

(0.030 in.) Gap