Kohler Command PRO ECV630 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Kohler Command PRO ECV630에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Command PRO ECV630 21 페이지. Vertical crankshaft
Kohler Command PRO ECV630에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

2. Check and clean the inlet screen. Pull the air

cleaner paper element out of the housing on

opposite side. See Figures 9 and 10.

Inlet Screen

Figure 9. Accessing Inlet Screen.

Paper Element

Figure 10. Removing Elements.

3. After the paper element is removed, check the

condition of the inner element. It should be

replaced whenever it appears dirty, typically

every other time the main element is replaced or

every 600 hours. Clean the area around the base

of the inner element before removing it, so dirt

does not get into the engine.

4. Do not wash the paper element and inner

element or use compressed air, this will damage

the elements. Replace dirty, bent or damaged

elements with new genuine Kohler elements as

required. Handle the new elements carefully;

do not use if the sealing surfaces are bent or

damaged.

5. Check all parts for wear, cracks, or damage, and

make sure ejector area is clean. See Figure 11.

Replace any damaged components.

Inner Element

Figure 11. Ejector Area.

6. Install the new inner element, followed by the

paper element. Slide each fully into place in the

air cleaner housing.

7. Reinstall the end caps and secure with the

retaining clips. See Figure 1.

Clean Air Intake/Cooling Areas

To ensure proper cooling, make sure the fixed guard,

cooling fins, and other external surfaces of the engine

are kept clean at all times.

Every 100 hours of operation (more often under

extremely dusty, dirty conditions), remove the blower

housing and other cooling shrouds. Clean the cooling

fins and external surfaces as necessary. Reinstall the

blower housing and other cooling shrouds.

NOTE: Operating the engine with a blocked fixed

guard, dirty or plugged cooling fins, and/or

cooling shrouds removed, will cause engine

damage due to overheating.

Ignition System

EFI Engines incorporate a computer-controlled battery

ignition system with individual coils. Other than

periodically checking/replacing the spark plugs, no

maintenance, timing, or adjustments are necessary or

possible with this system.

Check Spark Plugs

Every 200 hours of operation, remove the spark plugs,

check condition, and reset the gap or replace with

new plugs as necessary. The standard spark plug is a

Champion

RC12YC (Kohler Part No. 12 132 02-S). RFI

compliant engines use a Champion

Part No. 25 132 14-S) spark plug. A high-performance

spark plug, Champion

Series engines, Kohler Part No. 25 132 12-S) is also

available. Equivalent alternate brand plugs can also be

used.

Ejector

Area

XC12YC (Kohler

Platinum 3071 (used on Pro