Kohler Courage SH265 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Kohler Courage SH265에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Courage SH265 24 페이지. Albero motore orizzontale
Kohler Courage SH265에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (8 페이지), 브로셔 및 사양 (6 페이지), 소유자 매뉴얼 (9 페이지), 소유자 매뉴얼 (8 페이지), 사용 설명서 (24 페이지), 소유자 매뉴얼 (8 페이지), (영어) 사용 설명서 (18 페이지)

Kohler Courage SH265 소유자 매뉴얼

Stopping

1. If possible, remove the load.
2. Move the throttle control to the SLOW or LOW
idle position. Allow the engine to run at idle for
30-60 seconds. See Figure 11.
FAST
Figure 11. SLOW Position of Throttle Control.
3. Turn key switch or On/Off switch to the OFF
position. Move throttle to the STOP position if
equipped. See Figure 12.
On/Off
Switch
Figure 12. Engine On/Off Switch.
4. Close the fuel shut-off valve. See Figure 13.
Fuel
Shut-Off
Valve
OFF
Figure 13. OFF Position of Fuel Shut-Off Valve.
10
STOP
SLOW
STOP
(If Equipped)
Throttle
Control
OFF

Operating

Angle of Operation
Continuous operation at angles up to 25° with 1/2 full
fuel tank. Before operation check oil level to assure
crankcase oil level is correct. Refer to Check Oil Level.
Intermittent operation, up to one minute at angles up
to 30° with 1/2 full fuel tank. Check oil level to assure
crankcase oil level is correct. Refer to Check Oil Level.
Refer to the operating instructions of the equipment
this engine powers. Because of equipment design or
application, there may be more stringent restrictions
regarding the angle of operation.
NOTE: Do not operate this engine continuously
at angles exceeding 25° in any direction.
Engine damage could result from insufficient
lubrication.

Cooling

NOTE: If debris builds up on the debris screen
or other cooling areas, stop the engine
immediately and clean. Operating the engine
with blocked or dirty air intake and cooling
areas can cause extensive damage due to
overheating. Refer to Clean Air Intake/
Cooling Areas.
Hot Parts can cause severe burns.
Do not touch engine while operating or
just after stopping.
Engine components can get extremely hot from operation. To
prevent severe burns, do not touch these areas while the engine
is running, or immediately after it is turned off. Never operate
the engine with heat shields or guards removed.
Engine Speed
NOTE: Do not tamper with the governor setting
to increase the maximum engine speed.
Overspeed is hazardous and will void the
engine warranty. The maximum allowable
high idle speed for these engines is
3850 ± 100 RPM, no load.

Maintenance Instructions

Maintenance, repair or replacement of the emission
control devices and systems, which are being done
at the customers expense, may be performed by any
non-road engine repair establishment or individual.
Warranty repairs must be performed by an authorized
Kohler Engine Service Center.
WARNING