Kohler COURAGE SV710-740 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Kohler COURAGE SV710-740에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler COURAGE SV710-740 20 페이지. Vertical crankshaft
Kohler COURAGE SV710-740에 대해서도 마찬가지입니다: 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (21 페이지)

페이지 인쇄

3. Remove t heoilfill cap/dipstick; wipeoil off.

For

engines

with a press=on style dipstick:

Reinsert the dipstick

into the tube and press all

the way down. See Figure 5.

For engines

with a thread-on

style dipstick:

Reinsert the dipstick

into the oil fill tube and

thread the dipstick in completely.

See Figures 5

and 6.

Press=On

Figure 5. Dipstick

Styles.

'_Thread=On

incorrect

Correct

Oil Fill.

Cap/

Dipsti

Oil Fill

Tube

Figure 6. Thread-on

Oil Fill Cap/Dipstick.

Remove the oil fill cap/dipstick

and check

oil level. The oil level needs to be within the

operating

range. See Figure 7. If low, add oil of

the proper

type, up to the full mark. If oil is above

the "F" or FULL mark, drain oil to reach proper

level. Reinstall the oil fill cap/dipstick.

NOTE:

To prevent extensive

engine wear or damage,

always maintain

tile proper

oil level in tile

crankcase.

Never operate

the engine with

the oil level above tile "F" or FULL mark, or

below the "L" or LOW mark on the dipstick.

/XdN/_

××× Operatil

xxx

_x_

Range

Figure 7. Oil Level Marks on Dipstick

(Typical).

Oil Sentry

Some engines are equipped

with an optional

Oil

Sentry

oil pressure

switch. If the oil pressure

drops

below an acceptable

level, tile Oil Sentry

will either

shut off the engine or activate a warning

signal,

depending

on the application.

NOTE:

Make sure the oil level is checked BEFORE

EACH USE and is maintained

up to the FULL

or "F" mark on the dipstick. This includes

engines equipped

with Oil Sentry

TM.

Change

Oil and Oil Filter

Change the oil and oil filter annually

or every 100

hours of operation

(more frequently

under

severe

conditions).

Refill with service class SG, SH, SJ, or

higher oil as specified

in the Viscosity Grades table

(Figure 2) on page 4. Always use a genuine

Kohter oil

filter. Use chart below to determine

part number

order.

Oil Filter Part No.

Length

12 050 01-S

2-1/2"

52 050 02-S

3-3/8"

Change the oil while the engine is still warm. The oil

will flow more freely and carry away more impurities.

Make sure the engine is level when filling, checking, or

changing

the oil.

Figure 8. Oil Drain Plug.

Figure 9. Oil Filter Location.