Kohler K181 소유자 매뉴얼 - 페이지 2
{카테고리_이름} Kohler K181에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K181 8 페이지. Horizontal crankshaft
Kohler K181에 대해서도 마찬가지입니다: 운영 및 유지보수 매뉴얼 (17 페이지), 다국어 사용 설명서 (8 페이지)
페이지 인쇄
FUEL ON
TURN FUEL
VALVE TO
ON POS ITION
CHECK POLARITY
NEGATIVE ( - ) GROUND
SYSTEM USED
•
10
On engines with
AMP Magneto-Alternator, always dis connect leads hom Rectifier-Regulator
before doing any welding on equipment in common ground with engine .
•
To prevent overheating of starting motor, limit cranking time (continuous) to
2
minute period before recranking (limit Motor-Generator to
STOP BUTTON
•
Do nol add fuel while engine is running.
prevent spilled fuel from igniting on contact with hot engine parts.
•
Always disconnect spark plug cable t o prevent unintentional starting
adjustments on equipment powered by engine.
•
Make sure all safety guards on engine and driven equipment are in proper position and
secure.
•
Make sure hands,
starting.
•
Do not tamper with governor settings.
These limits must not be exceeded.
STARTING PROCEOURE
CLOSE CHOKE
GRADUALLY RETURN
CHOKE TO OPEN
POSITION AFTER
ENGINE STARTS
CRANK ENGINE (ELECTRIC START
STOPPING PROCEDURE
DEPRESS AND
HOLD BUTTON
UNTI L ENG I NE
COMPLETELY STOPPED
SAFETY PRECAUTIONS
Stop engine and, if possible, allow cooling period to
feet, and clothing are at a safe distance from any movable parts prior to
The governor establishes safe operating limits.
2
CRANK ENGINE (HAND)
PULL IN
DI RECTION
SHOWN - USE
STEADY MOTION
1.
PULL IGNITION
KNOB OUT*
2.
DEPRESS AND HOLD
START BUTTON UNTIL
ENGINE STARTS
*OR MOVE TOGGLE
SWITCH TO "ON" POSITION
30
seconds cranking).
STOP
SWITCH
before
making any
60
seconds then allow
PUSH KNOB IN
OR MOVE SWITCH
TO "OFF" POSITION