Kohler KT19 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Kohler KT19에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler KT19 17 페이지. Series ii

페이지 인쇄

Change Oil Filter

Some engines are equipped

with an oil filter. Replace

the oil filter every other oil change,

in accordance

with

the "Oil Change Intervals" table on page 8. Always

use a genuine Kohler oil filter, Part No. 52 050 02, and

replace as follows:

1 .

3 .

4 .

6 .

8 .

Drain the oil from the engine crankcase.

Allow the oil filter to drain.

Remove the old filter and wipe the filter adapter

gasket surface.

Place a new replacement

filter in a shallow pan

with the open end up. Pour new oil of the proper

type, in through the threaded

center hole. Stop

pouring when the oil reaches the bottom of the

threads.

Put a drop of oil on your fingertip and wipe it on

the rubber gasket. Allow a minute or two for the

oil to be absorbed

by the filter material then

install it on the engine. Turn the oil filter clockwise

until rubber gasket contacts the filter adapter,

then tighten filter an additional

l/2 turn.

Reinstall drain plug. Make sure it is tight.

Fill the crankcase

with new oil of the proper type

to the 'IF" mark on the dipstick. Add an additional

l/2 pint of oil for the filter capacity. See

"Specifications"

on page 15.

Test run the engine to check for leaks. Stop the

engine, allow a minute for the oil to drain down,

and recheck the level on the dipstick. Make sure

oil level is up to but not over the "F" mark on the

dipstick.

Figure 6. Oil Filter and Optional

Oil SentryTM Switch.

Service Precleaner and Air Cleaner Element

This engine is equipped with a replaceable,

high

density paper air cleaner element.

Some engines are

also equipped with an oiled, foam precleaner

which

surrounds

the paper element. See Figure 7.

Element

Cover Seals

Precleaner

Air Cleaner

Base

Element

Figure 7. Air Cleaner Housing

Components.

Check the air cleaner daily or before starting the

engine. Check for buildup of dirt and debris around

the air cleaner system. Keep this area clean. Also

check for loose or damaged components.

Replace all

bent or damaged air cleaner components.