Kohler 10RESV 설치 매뉴얼 - 페이지 33

{카테고리_이름} Kohler 10RESV에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 10RESV 48 페이지. Residential/commercial generator sets
Kohler 10RESV에 대해서도 마찬가지입니다: 설치 지침 (2 페이지)

페이지 인쇄

2.1 Introduction

This section describes some of the accessories that are

available for the generator sets. Have accessories

installed by an authorized distributor/ dealer or a

licensed electrician. This document does not contain

installation instructions for accessories. Follow the

installation instructions provided with each kit.

Use separate conduit for AC and DC leads to reduce the

possibility of electrical interference. Verify that the leads

and conduit do not interfere with the operation of the

generator set or obstruct the service areas. Verify that

the electrical installation complies with the National

Electrical Code (NEC) and all applicable local codes.

See the wiring diagrams in Section 3 for more

information

regarding

connections.

2.2 Connect Optional

Programmable Interface

Module (PIM)

The optional programmable interface module (PIM)

provides two programmable inputs and six dry contact

outputs, four of which are programmable. See TT-1584

for PIM installation and connection instructions. Also

see Section 1.10 of this manual for connection to the

generator set.

The default settings for the inputs and outputs are

shown in Figure 2-2. To change the input and output

settings, use a personal computer running Kohler

SiteTechr software. See TP-6701, SiteTech Software

Operation Manual, for instructions.

Kohler OnCuer Plus can be used to actively control PIM

outputs. See the OnCue Plus Operation Manual for

instructions.

TP-6984

5/17a

generator

set

electrical

Section 2 Accessories

1. Output connections (3 terminal blocks, 6 outputs)

2. Input connections (2 inputs)

3. RBUS communication connection to generator set terminal

block TB2

Figure 2-1 Optional PIM

PIM Connection

Factory Default Setting

Input 1

None

Input 2

None

Output 1 (Relay 1)

Run

Output 2 (Relay 2)

Common Fault

Output 3 (Relay 3)

Low Battery Voltage (Program-

mable)

Output 4 (Relay 4)

Not in Auto (Programmable)

Output 5 (Relay 5)

Cooldown (Programmable)

Output 6 (Relay 6)

Normal Source Failure (Program-

mable)

Figure 2-2 PIM Inputs and Outputs

ADV-8199

Section 2 Accessories