Kohler 12RES 설치 매뉴얼 - 페이지 24

{카테고리_이름} Kohler 12RES에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 12RES 44 페이지. Residential/commercial generator sets
Kohler 12RES에 대해서도 마찬가지입니다: 운영 매뉴얼 (36 페이지), 운영 (48 페이지)

페이지 인쇄
Kohler 12RES 설치 매뉴얼

1.10.2 Carburetor Heater

An optional carburetor heater is recommended for
improved cold starting in locations where the ambient
temperature drops below 0 C (32 F). The carburetor
heater prevents condensation and carburetor icing. The
heater turns on when the temperature at the thermostat
falls below approximately 4 C (40 F) and turns off when
the temperature rises above approximately 16 C
(60 F). See Figure 1-25.
The carburetor heater thermostat is installed in the cord.
Figure 1-26 shows the location of the thermostat on the
power cord. The heater power cord and thermostat are
located in the generator set housing air intake area/
battery compartment. See Figure 1-21.
Note: Do not place the carburetor heater thermostat
inside the generator set engine compartment.
The thermostat must be exposed to the ambient
air.
The heater requires a continuous source of power. Plug
the carburetor heater into an outlet that supplies
continuous 120 VAC power .
1
1. Power plug
Figure 1-26 Carburetor Heaters
24
Section 1 Installation
2
2. Thermostat
1
1. Carburetor heater (air cleaner removed to show heater)
2. Carburetor heater power cord
Figure 1-25 Carburetor Heater Location
3. Heater
2
3
GM19463
TP-6967 2/21
tp6195