Kohler 18RESHD 설치 매뉴얼 - 페이지 25

{카테고리_이름} Kohler 18RESHD에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 18RESHD 40 페이지. Residential/commercial generator sets
Kohler 18RESHD에 대해서도 마찬가지입니다: 운영 (48 페이지)

페이지 인쇄

Note: The generator set will not start and circuit board

damage may occur if the battery is connected in

reverse.

Figure 1-22 shows the location of the engine starting

battery.

Standard battery cables provide easy

connection to the battery. Use the following procedure

to install and connect the battery.

1. Engine starting battery location

Figure 1-22 Battery Location, Air Intake End

TP-6516 4/09

Battery Installation Procedure

1. Ensure that the starting battery is fully charged

before placing the battery in service.

2. Clean the battery posts and/or adapters if

necessary.

3. Install the battery post adapters, if needed.

4. Place the battery in the housing.

5. Verify that the controller master switch is in the OFF

position.

6. Connect the positive (+) lead to the engine starting

battery.

7. Connect the negative (--) lead to the engine starting

battery.

Refer to the generator set Operation Manual and the

ADV-7341A-B

battery

maintenance instructions.

manufacturer's

instructions

Section 1 Installation

for

battery