Kohler 18RESNT 설치 매뉴얼 - 페이지 26

{카테고리_이름} Kohler 18RESNT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 18RESNT 40 페이지. Residential/commercial generator sets
Kohler 18RESNT에 대해서도 마찬가지입니다: 운영 (48 페이지)

페이지 인쇄

1.10 Carburetor Heater (optional)

Have accessories installed by an authorized distributor/

dealer or a licensed electrician. Follow the installation

instructions provided with each kit. Use separate conduit

for AC and DC leads to reduce the possibility of electrical

interference. Verify that the leads and conduit do not

interfere with the operation of the generator set or

obstruct the service areas. Verify that the electrical

installation complies with the National Electrical Code

(NEC) and all applicable local codes. See Section 2,

Wiring Diagrams, for more information regarding

generator set electrical connections.

An optional carburetor heater is recommended for

improved cold starting in locations where the ambient

temperature drops below 0_C (32_F). The carburetor

heater prevents condensation and carburetor icing. The

heater turns on when the temperature at the thermostat

falls below approximately 4_C (40_F) and turns off when

the temperature rises above approximately 16_C

(60_F). See Figure 1-23 through Figure 1-26.

The heater thermostat is installed in the cord.

Figure 1-26 shows the location of the thermostat on the

power cord.

1. Carburetor heater (air cleaner removed to show heater)

2. Carburetor heater power cord

Figure 1-23 Carburetor Heater Location, 12 kW

The heater requires a continuous source of 120 VAC

power. The heater power cord and thermostat are

located in the generator set housing air intake area/

Section 1 Installation

tp6195

battery

compartment.

Figure 1-24. Plug the carburetor heater into an outlet

that supplies continuous 120 VAC power.

Note: Do not place the heater thermostat inside the

generator set engine compartment.

thermostat must be exposed to the ambient air.

Thermostat will shut off power to the heater when

ambient temperature reaches approximately

16_C (60_F).

Figure 1-25 shows the location of the carburetor heater

on the 17/18 kW generator set engine for reference.

(The engine has been removed from the generator set in

this photo for a clear view.)

1. Thermostat

2. Heater

3. Bulkhead opening for carburetor heater access

4. Carburetor heater cord with thermostat

5. 120 VAC receptacles for carburetor heater and

battery charger

Figure 1-24 Carburetor Heater, 17/18 kW

1. Carburetor heater location

Figure 1-25 Carburetor Heater Location, 17/18 kW

See

Figure 1-22

and

The

GM57969

tp6514

TP-6516 4/09