Kohler 19.5EFKOZD 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} Kohler 19.5EFKOZD에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 19.5EFKOZD 8 페이지.
Kohler 19.5EFKOZD에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지)

페이지 인쇄

Installation Procedure

Remove the generator set from service.

1.1

Press

the

generator

OFF/RESET button.

1.2

Disconnect the power to the battery charger, if

equipped.

1.3

Disconnect the generator set engine starting

battery, the negative (--) lead first.

Remove the sound shield door and roof.

2.1

Remove the sound shield's engine-end (front)

door and roof (if necessary) to gain access to the

generator set hoses inside. See Figure 2.

1. Engine-end (front) door

2. Customer connection panel

3. Button plugs (qty. 2)

4. Roof

Figure 2 Sound Shield

2.2

Open the service doors.

2.3

Release/untighten the three wing nuts located

underneath the roof. See Figure 3.

2.4

Lift up the roof.

2.5

Slide the roof towards the service side of the unit

for removal.

2.6

Open the front, rear, and non-service side doors

as needed.

set

master

control

1. Sound shield roof

2. Wing nut

3. Service door

Figure 3 Sound Shield Roof Removal

Install the siphon break.

3.1

Remove the 2 button plugs from the customer

connection panel. See Figure 2.

3.2

Install the 2 grommets (X-284-42) and 2 hose

connectors (344934) to the openings in the

customer connection panel. See Figure 8.

3.3

Find and remove the hose (X-312-49) located

between the heat exchanger end cap and the

exhaust mixer. Save the hose clamps, tee, and

pressure switch. Keep the elbow in position on the

exhaust mixer.

Nonservice-Side

1. Elbow on exhaust mixer (elbow not shown)

2. Tee, pressure switch, and hose clamps

3. Hose (X-312-49)

Figure 4 Hose Removal

GM89517

View

TT-1664

6/15