Kohler KDI 1903M 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Kohler KDI 1903M에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler KDI 1903M 38 페이지. Diesel kdi
Kohler KDI 1903M에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (50 페이지), 사용 및 유지 관리 (42 페이지)

페이지 인쇄

• Fully tighten the tank cap each time after refuelling. Do not

fill the tank right to the top but leave an adequate space for

the fuel to expand.

• To start the engine follow the specific instructions provided

in the engine and/or machine operating manual. Do not

use auxiliary starting devices not originally installed on the

machine (e.g. Startpilot).

• Before starting, remove any tools that were used to service

the engine and/or machine. Make sure that all guards have

been refitted.

• Do not mix fuel with elements such as oil or kerosene. Failure

to comply with this prohibition will cause the non-operation of

the catalyst and non-observance of the emissions declared

by KOHLER.

• Pay attention to the temperature of the oil filter when the filter

itself is replaced.

• Only check, top up and change the coolant fluid when the

engine is off and reached the ambient temperature. Coolant

fluid is polluting, it must therefore be disposed of in the correct

way.

• Do not use air and water jets at high pressures on cables,

connectors and injectors.

α ≤ 15°

Fig. 2.1

UM KDI 1903M_2504M _ cod. ED0053029500 - 2° ed_rev. 01

SAFETY INFORMATION

Important

• Only use the eyebolts A installed by KOHLER to move the

engine (Fig. 2.1).

• The angle between each lifting chain and the eyebolts shall

not exceed 15° inwards.

• The correct tightening of the lifting screws is 25Nm.

• Do not interpose spacers or washers between the eyebolts

and engine head.

• Provided that the above requirements are met, if the lifting

eyebolts are subject to permanent deformation (inwards), all

subsequent lifting operations must be performed in order to

prevent them from bending in the opposite direction.

α ≤ 15°

Index