Kohler Power Systems KD Series 설치 지침 - 페이지 2

{카테고리_이름} Kohler Power Systems KD Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Power Systems KD Series 4 페이지. Generator sets with apm802 controller

페이지 인쇄

Safety Precautions

Observe the following safety precautions while

installing the kit.

WARNING

Accidental starting.

Can cause severe injury or death.

Disconnect the battery cables before

working

Remove the negative (--) lead first

when disconnecting the battery.

Reconnect the negative (--) lead last

when reconnecting the battery.

Disabling the generator set.

cause severe injury or death.

generator set or equipment connected to the set, disable the

generator set as follows: (1) Shut down the generator set. (2)

Place the controller in Out of Service mode. (3) Press the

emergency stop button. (4) Disconnect the power to the

battery charger, if equipped. (5) Remove the battery cables,

negative (--) lead first. Reconnect the negative (--) lead last

when reconnecting the battery. Follow these precautions to

prevent the starting of the generator set by the remote

start/stop switch.

DANGER

Hazardous voltage.

Will cause severe injury or death.

Disconnect all power sources before

opening the enclosure.

the

generator

set.

Accidental starting can

Before working on the

Installation Procedure

1. Before working on the generator set or connected

equipment, disable the generator set. Refer to the

safety precautions for preventing accidental starts

and disabling the generator set.

a. Remove the load from the generator set.

b. Shut down the generator set.

c. Place the generator set controller into

Out-of-Service

emergency stop button.

d. Disconnect the power to the battery charger.

e. Remove the battery cables negative (--) lead

first to disable the generator set.

2. To access the terminal block, TB10, remove the

eight screws from the lower compartment cover on

the control panel. See Figure 3.

3. Remove jumper from terminals TB10-1 and 2.

1. Lower compartment

cover

2. TB10

3. 38 mm (1-1/2 in.) holes

Figure 3 Lower Compartment Component Location

mode

and

press

TT-1719

12/16

the