Kohler K-8211 설치 매뉴얼 - 페이지 7

{카테고리_이름} Kohler K-8211에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-8211 21 페이지. Widespread lavatory faucets
Kohler K-8211에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (36 페이지), 설치 및 관리 매뉴얼 (21 페이지)

페이지 인쇄

Install the Drain (cont.)

Insert the short end of the rod into the seal hole and under the

stopper. Loosely secure in place with the rod nut.

Push the rod down to open the drain.

Insert the stopper into the drain assembly.

Remove and adjust the stopper so it lifts approximately 3/8" (1

cm) when opened. To adjust, hold the stopper bolt and turn the

stopper counterclockwise to raise and clockwise to lower.

Reinstall the stopper.

For Vandal-Resistant Installations: Remove the rod nut. While

the stopper is in place, insert the end of the rod through the hole

in the stopper bolt. Secure the rod with the rod nut.

For All Other Installations: Tighten the rod nut to secure the rod.

Identify the best hole in the link to allow full operation of the rod

and the lift rod.

Align the link hole with the rod and slide the clip and the link

onto the rod with the thumbscrew facing the back of the lavatory.

To move the link to the proper position, squeeze the clip and

slide it along the rod.

Align the link with the faucet lift rod and push the lift rod

through the hole in the link. If required, loosen the thumbscrew

on the link.

Verify that the lift rod knob rests on the escutcheon when the

drain is in the full open position.

Tighten the thumbscrew to secure the lift rod position.

Kohler Co.

1002628-2-P