AcalaQuell Grande 사용자 설명서 - 페이지 4

{카테고리_이름} AcalaQuell Grande에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AcalaQuell Grande 12 페이지.

1. Remove all packaging from the system and the filter.

2. Clean all the holders and parts of the system with a mild soap or cleaning agent - apart from the

filters and the mineral rocks – and rinse them thoroughly with clean water.

IMPORTANT:

. Never use soap or a cleaning agent on the filter cartridge, mineral stones, the ceramic filter or the

lime filter

. Do not use boiling water and don't put any parts into a dish washer

. Only use gentle cleaning agents to avoid scratching glass or plastic

. Hygiene: Only assemble using disposable gloves or well-cleaned hands. Do not put the cleaned

parts, the filters and rocks on the kitchen table or other surfaces that come into contact with

groceries. Use fresh cloths and plates.

3. Put the drinking water container on the base.

4. Install the tap.

Install the tap. Dry the installation area thoroughly. The 2 sealing rings are used respectively on the

inside and outside of the drinking water container. Slide a washer over the thread to the end of the

tap and then through the hole in the glass container. Now slide the washer for the inside over the

end of the thread in the water container. Tighten the screw firmly with your hand so that both

sealing rings sit tight on the wall of the container and closewatertight. The sealing rings should

deform only slightly when tightened.