AcalaQuell Mini 사용자 설명서 - 페이지 5

{카테고리_이름} AcalaQuell Mini에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AcalaQuell Mini 12 페이지.

AcalaQuell Mini 사용자 설명서
5. The filter cartridge previously removed from the hygiene pack must be watered and vented
before insertion. Place the filter cartridge in a container, with the thread upwards, so that there is at
least 10 - 15 cm of water above the submerged cartridge. Leave the filter cartridge in the water for
about 20 minutes. Then screw the cartridge loosely into the threaded ring and hang both together in
the drinking water tank.
6. Open the lime filter (this is optional and is not part of the standard delivery), take out the bag,
cut a hole in it and put in the contents of the bag. Close the lid until it clicks into place and then
rinse the lime filter for about 5 minutes with drinking water. Put the lime cartridge into the threaded
ring.
7. Rinse the ceramic filter with drinking water until the air has gone. Then put it into the upper tank
in the designated opening.Only mount the wing nut hand-tight.
8. Slide the ring from below onto the ceramic thread. Tighten the filter with your hand. Now put the
upper tank with the ceramic filter onto the drinking water container with the installed cartridge.
9. Fill the uper tank using a suitable vesel until it is full.
10.Dispose of the first 3 fillings of the drinking water container (about 5/8/10 litres) or pour it on
your plants – they will love it. All materials are filled only loosely and without glue in the cartridge,
therefore, for example, dust can be released during transport. However, this is absolutely safe and is
rinsed with the first 3 rinses.
11. Boil 2-3 pieces of mineral
for a few minutes with a pinch of salt (preferably something as
stones
biologicaly valuable as Acala crystal salt). Next rinse the
stones
under running water. Only put the stones in the glass when they are cold. Put the stones on the
bottom of the glass tank. Make sure you do not let the cartridge lie on the stones when you insert it
into the tank.
NOTE:
The mineral output of the stones is initialy much higher than at the end of their use.
Therefore it make sense to start of with just a few and then add bit by bit some more until the full
pack has been used.
Should your drinking water taste to strong, please reduce the amount of stones tobtain the desired
taste. The stones influence the taste, the more you use the spicier the water. So you can control the
taste of your water.