2T Technology ME-D-3G 빠른 시작 매뉴얼

{카테고리_이름} 2T Technology ME-D-3G에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2T Technology ME-D-3G 2 페이지. Voyager digital intercom

Quick Start Guide

1. Purchase a bill pay or pay as you go (PAYG) SIM card. Get the security PIN removed and ask to have

Voice Mail turned off.

2. If the SIM is PAYG, register the SIM online at the operator's web site. You are likely to have to put the

SIM into a phone for the relevant network to receive a registration code. Having the SIM registered will

allow the end user check the credit on the SIM. Give the end user the login details for checking SIM credit.

3. Fit the SIM Card into the device (slide the top of the SIM holder towards the antenna connector until it

clicks and opens). Connect the PSU to the terminals GND and 12V on the terminal block as per the wiring

diagram on the back of the unit. Connect up the antenna cable. Apply power to the GSM device.

4. Give the device about 2 minutes to register when first turned on. The LCD should now a) indicate the

available signal strength on the ICON at the top left of the screen and b) the message "Enter Flat Number

then Call" should be on the LCD screen.

5. Move the antenna away from the intercom to minimise the GSM hum on the speaker during a call.

The keypad can be used to pulse the relay to control a lock or gate. To do this the feature must be enabled as

follows:

1. To Enter Configuration Mode. Press A and then enter the default manager code "123456".

2. Press the D button twice to enter the Main menu.

3. Press the D button to enter the Manager menu.

4. Use the # key to move down to "Door Setting" and press the D button.

5. Press the D button on "Open by Password" and use the D button to change from Disable to Enable.

6. Use the A key to reverse out of the menus to go back to the main screen.

Test the configuration:

7. To operate the relay, enter the default code "123456" and then press A. Relay should pulse and

"Door is open" will show on screen.

Three numbers can be added per call point. So each apartment or associated user can have three phone

numbers associated with them. If one number isn't answered the second one will be called. To set up a user:

1. To Enter Configuration Mode. Press A and then enter the default manager code "123456".

2. Press the D button twice to enter the Main menu.

3. Use the # key to move down to Subscriber and press the D button to set up a subscriber.

4. Enter "1" and press D to add numbers in location 1, or for apartment 1.

5. Use the # button to move to "Yes" and press the D button.

6. At the flashing "N" for name press the D button and add the users name using the keypad (See the

bottom of page 2 for keypad layout) and use # key to move to next letter and press the D button

when finished.

7. Beside 1: enter the first phone number.

8. If required beside 2: add a second phone and beside 3: add a third number for this user or apartment.

9. Use A button to exit configuration menu when programming complete.

Test the configuration:

10. Now test the intercom by placing a call to User or Apartment 1.

11. At the main screen press "1" and then press the D button. The call should go through to the number

you programmed for user or apartment 1.

Ver 1.0

Voyager Digital Intercom (ME-D-3G)

Using the Keypad for Access Control

Setting up details for a User or Apartment and make a call