2VV BASIC 매뉴얼 - 페이지 8

{카테고리_이름} 2VV BASIC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2VV BASIC 11 페이지. Electric door heater

7. SWITCHING ON FOR THE FIRST TIME

DO NOT OVERLOOK

Before starting the air curtain with an RF control module, check the following:

Did you leave any tools or items inside the curtain which could damage it?

•

There a corresponding el. power supply available including sufficient protection.

•

Did you close the air curtain correctly?

•

Carefully read the following chapter before connecting the air curtain.

8. CONTROLS

8.1 DESCRIPTION OF THE REGULATION AND ITS CONTOLS

Air curtain without a heater:

Start the device by pressing the

to decrease fan speed. Selected fan speed is indicated by lights on the integrated control panel. Turn the device off again using

the

button.

Air curtain with an el. heater:

Start the device by pressing the

crease fan speed. Use the

is indicated by lights on the integrated control panel. Turn the device off again using the

it automatically performs aftercooling of the electric heating element for 30 seconds and then turns itself off. The aftercooling of

the heat exchanger is indicated by a flashing speed 1 on integrated panel.

Programming (pairing):

This mode is active 30 seconds after power ON of unit (when there was no power supply before).

Press all four buttons on controller at least of 4 seconds. If unit will blinking with fan 1 and fan 2 speed simultaneously, then pairing

was succesfull. If blinking is alternately, then controller is already paired, or there was reached maximum count of controllers (max.

60 controllers per unit).

button on the remote control. Then you can use the speed button

ON/OFF

button on the remote control. Then you can use the speed button

button to select whether the heater will be on or off. The operation of the fan and the electric heater

ON/OFF

to increase or

button. When the device is turned off,

to de-