Aqua 9+ AQ9-200GPD 설치 매뉴얼 - 페이지 7

{카테고리_이름} Aqua 9+ AQ9-200GPD에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua 9+ AQ9-200GPD 13 페이지. Natural ionic calcium alkaline water system

Installation Manual ::

Aqua 9+ Natural Ionic Calcium Water System

DRILLING FAUCET HOLE IN SINK

Stainless Steel Sinks & Porcelain Sinks:

1. Drilling through a stainless steel sinks can be achieved by marking a center punch & drilling

a 3/8" guide hole.

2. Use a 7/16 or 1/2" carbide drill to enlarge the hole.

3. For porcelain sinks, mark the location of the hole. Use some masking tape to protect the

area where the hole is to be drilled on the sink surface. Use a 7/16 or 1/2" drill. Make sure

when starting a drill, to begin slowly through the porcelain portion of the sink so that chip-

ping is cut down to minimum.

MOUNTING THE FAUCET

1. Disassemble the bottom portion of the faucet

2. Place into hole of sink and reassemble faucet from underneath sink (see figure 5)

3. Tighten nut on faucet bottom while keeping faucet straight as desired on sink.

4. Connect 1/4" tubing to bottom of the faucet shank using the insert, ferrule, and

compression nut.

Figure 5. Faucet Assembly

Faucet

Threaded Shank

Plastic Washer

(Optional Chrome

Plated Brass Washer)

Rubber Washer

Hole for Spray Hose

(or Drill. new 1/2" Hole)

Locating Washer

Locking Washer

Brass Nut

Brass lnsert

Plastic Ferrule -(tape part should

point towards faucet shank)

Brass Compression Nut

1/4" Tubing

STANDARD FAUCET