Aqua Comfort ACT750 보정 및 설정 - 페이지 2
{카테고리_이름} Aqua Comfort ACT750에 대한 보정 및 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Comfort ACT750 2 페이지.
페이지 인쇄
THE POOL HEATING SOLUTION
Calibrating the Water Temperature
1.
Hold down the "Up" and "Down" arrows for approximately 10 seconds
2.
Unit will display " F – C " , this is the calibration for Fahrenheit or Celsius
3.
Press the "Hand" button until it reads the " tSC " on the display
4.
Press the " Up" or "Down" Arrow and the display should read a "0"
5.
Calibrate up or down using the arrows depending on the difference in display temperature versus
actual water temperature. Example: If the actual water temp. is 85 degrees but the unit is reading
80 degrees, the difference is + 5, so adjust the " 0 " so it reads " 5 ".
6.
Once the calibration is made wait 10 seconds for the display to time out and go back to the normal
display. The unit should now display the correct water temperature.
How To Adjust the DeadBand or "db" ( amount of temperature the unit will stay off)
1.
Hold down the "Up" and "Down" arrows for approximately 10 seconds
2.
Unit will display " F – C " , this is the calibration for Fahrenheit or Celsius
3.
Press the "Hand" button until it reads the " db " on the display
4.
Press the " Up" Arrow and the display should read a "0" or higher
5.
Press the "Up" Arrow until the desired deadband is reached
6.
Once the selection is made wait 10 seconds for the display to time out and go back to the normal
display.
How to the Adjust the DEF ( defrost mode ) between " AIr" ( air defrost) and "rEC" (reversing
valve defrost)
1.
Hold down the "Up" and "Down" arrows for approximately 10 seconds
2.
Unit will display " F – C " , this is the calibration for Fahrenheit or Celsius
3.
Press the "Hand" button until it reads the " DEF " on the display
4.
Press the " Up" Arrow and the display should read "AIr" ( air defrost )
5.
If the heat pump is a Heat/Cool model you may select the unit to defrost using the reversing valve.
Press the "down" arrow and the display should read "rEC" for ( reversing valve defrost)
6.
Once the selection is made wait 10 seconds for the display to time out and go back to the normal
display.
How to By-pass the heat pump's 5 minute delay
1.
Hold down the "Up" and "Down" arrows for approximately 10 seconds
2.
Unit will display " F – C " , this is the calibration for Fahrenheit or Celsius
3.
Press the "Hand" button until it reads the " DEL " on the display
4.
Press the " Up" Arrow and the display should read "00" and the Fan motor will start
5.
Press the "Up" arrow again and the display should read "01" and the compressor will start
6.
Once the selection is made wait 10 seconds for the display to time out and go back to the normal
display.