AvL Technologies Vector Compass 설정 및 운영 매뉴얼 - 페이지 6

{카테고리_이름} AvL Technologies Vector Compass에 대한 설정 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AvL Technologies Vector Compass 11 페이지.

페이지 인쇄

Long Name

Vector Compass Enable

Vector Compass Reset

Vector Compass Com Port

Settings

Vector Compass Heading

Offset

Vector Compass Separation

Vector Compass Scan Width

GPS Source

Heading Averaged

Primary Heading Source

Secondary Heading Source

Time Source

AvL Technologies

Level

Type

Value Range

Integer

String

Float

-180.0 to 180.0

Float

0.0001 to 10.0

Float

0.0 to 400.0

Manual GPS, NAV

Choice

RIOM GPS, Vector

Compass GPS

Choice

Yes, No

No Compass, GPS,

Compass, Manual,

Choice

SatTant, Vector

Compass, AvL GPS

No Compass, GPS,

Compass, Manual,

Choice

SatTant, Vector

Compass, AvL GPS

None, NTP, Vector

CompassGPS,

Choice

XML, NAV RIOM

GPS, Manual Time

| Proprietary – Content is Subject to Change without Notice

Vector Compass

This flag indicates that the compass

should be used and powered. This is set

0 or 1

at the factory and should not be changed

This flag resets the power supplied to the

Vector Compass when set to "1". This is set

0 or 1

at the factory and should not be changed by

This is the Com Port used by the Vector

Compass to communicate with the

controller. This is set at the factory and

should not be changed by the user.

The communications parameters for the

comm port in the form of BuadRate DataBits

StopBits Parity (ie 9600 8 1 0) where parity

values are 0 for none and 1 for even. This is

set at the factory and should not be changed

The offset in degrees of the vector compass

device. This is set at the factory and should

not be changed by the user

Separation parameter used to initialize the

vector compass. This is set at the factory

and should not be changed by the user.

Scan width to use during an Acquisition with

the Vector Compass as the Heading Source.

The device to use as the source of the GPS

location. Needs to be set to "Vector

Flag indicating the heading should be

averaged during the dwell time.

The device to use as the primary source of

the heading. Needs to be set to "Vector

The device to use as the heading source if

the primary source fails

Time source used by the controller for time

synchronization Needs to be set to "Vector

Documentation

by the user.

the user.

by the user.

Compass"