Aqua Computer TUBEMETER 소유자 매뉴얼

{카테고리_이름} Aqua Computer TUBEMETER에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Computer TUBEMETER 2 페이지.

aqua
computer
Owner's manual for the tubemeter™
Dear customer,
we thank you for the purchase of a tubemeter™. With this highly developed USB- and
aquabus liquid level sensor you are receiving a dependable controlling device to monitor
an important system parameter of your water cooling. Changes in the liquid level can now
be detected at an early stage and failures of the system thus be prevented. In coordination
with other components a complete monitoring of your system is realisable.
The dimensions of the tubemeter™ were optimized for the usage in our aquatube™ and
aquainlet™, but an installation in many devices from other manufacturors is also possible.
The high density and modernly produced circuit board allows an installation via the USB or
aquabus connector. The used connector is automatically detected. Every component is
individually tested by us prior to shipment.
Included in delivery:
Included in delivery:
Included in delivery:
Included in delivery:
One liquid level sensor tubemeter™, pre-finished and sealed in a metall casing,
one internal USB-cablel (5-pin), length approx. 70 cm.
Intended usage:
Intended usage:
Intended usage:
Intended usage:
Sensor for the determination of the liquid level in destilled water with a 2% additive of
ACfluid™. Measuring system is based on the conductivity measurement between the
sensors.
Technical data:
Technical data:
Technical data:
Technical data:
Operating voltage
Current consumption
Measuring range
Installation thread
Outer dimension of the casing
Dimension of the controller
Connection:
Connection:
Connection:
Connection:
Pin 1 is marked on the front and back of the circuit board. Pin assignment:
Pin 1 NC
Pin 2 GND
Pin 3 USB D+ or data line (SDA)
Pin 4 USB D- or clocking line (SCL)
Pin 5 +5 V
Only use original Aqua Computer connection cables!
ATTENTION:
ATTENTION:
ATTENTION:
ATTENTION: Double-check the exact pin-assignment on the sensor and mainboard
respectively aquaero. Do not under any circumstances rely on markings on connectors or
cables!
© 2005-2007
5,0 V DC +/- 10%
max. 20 mA
approx. 52 mm
G 1/8, sealed with a rubber gasket
16,9 mm
approx. 110x25x94 mm
Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1 – D-37130 Gleichen
Current as of 01/2007
MANUAL TUBEMETER
Page 1