AAVIX AGT310A 소유자 매뉴얼 - 페이지 8

{카테고리_이름} AAVIX AGT310A에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AAVIX AGT310A 13 페이지. Led; 9 v

Rotate the control counter clockwise to the end to get ALL

METAL mode. All METAL also comes with auto ground

balance. It's used to ﬁnd not only ferrous metal, but also

non-ferrous one (see more details below).

b. VOLUME — Rotate the control clockwise to power on the

unit. Rotate it fully counter clockwise to power oﬀ the unit.

c. SENS — Rotate the control clockwise to get higher sensitivity.

Rotating it counter clockwise to decrease it.

d. LOW BAT — Low battery indicator. When LOW BAT indicator

lights, user should replace the batteries at once.

e. EAR — It's a 0.14inch headphone jack for connecting

headphones.

f. View meter — When unit ﬁnds any metal target, the meter

pointer swings to the right.

TESTING AND USING THE DECTECTOR

The metal detector has two operation modes: ALL METAL &

DISC. All metal is used to ﬁnd all kinds of metal targets. DISC is

used to discriminate the metal type.

In general case, user ﬁrstly sets the operation mode to ALL

METAL, DISC to counter clockwise end, SENS to high position.

Then hold the search coil parallel with the ground about

0.4~2inch above the surface. Sweep the search coil from side to

side in an arc line of 2.7inch motion.

When the detector detects a buried target, it sounds a tone.

User can make a visual note of exact spot on the ground where

the detector beeps.