AAVIX GC-1032 소유자 매뉴얼 - 페이지 10

{카테고리_이름} AAVIX GC-1032에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AAVIX GC-1032 15 페이지.

1¢: It indicates that the target might be a zinc penny. Some

large rough gold items might register within this category.

25¢: It indicates that the target is probably 25¢ or a silver coin.

3. Tones

The detector comes with three tones for different types of metal.

But the built in audio identification system sounds a unique tone

for each of three categories of metal. This makes it easier to

identify the metal being detected.

A low tone is for IRON, 5¢, same as for foil, bottle cap or nickels. A

medium tone is for P-TAB, ZN, 1¢(aluminum pull tabs, zinc or

copper items). A high tone is for 25¢,same as for brass or silver

items.

Notes:

When you set the detector to DISC or NOTCH mode, the



detector sounds a medium or high tone when it detects highly

oxidized iron.

Depending on the purity, about 15 percent of gold rings cause



the detector to sound a medium tone.

OUTDOOR TESTING AND USE

1. Rotate the VOLUME switch clockwise away from OFF to power on

the detector.

2. Follow the steps of 2 described in section of Indoor Testing and

Use to set the operating mode.

3. Find an area on the ground outside where there is no metal.

4. Place a sample of the material you want the detector to find (such

as a gold ring or a coin) on the ground.

Note:

If you are using valuable metal such as gold to test the detector, mark

the area where you place the item, to help you find it later. Do not place

it in tall grass or weeds).

5. Hold the search coil level to the ground about 1~2 inches above

the surface, slowly move the search coil over the area where you