Aqua Computer multiswitch 1.41 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Aqua Computer multiswitch 1.41에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Computer multiswitch 1.41 12 페이지. Firmware-version 1.06 os- version 1.02

페이지 인쇄

MULTISWITCH

handle PWM signals before

may result in the destruction of the connected devices!

If the multiswitch™ is used as an aquabus-device on the aquaero, the

PWM function is always deactivated and the jumper setting is ignored.

Jumper open:

Jumper closed:

Jumper position 4: Button function

This jumper configures the functions of the buttons on the front of the

device (supprted only in devices with buttons).

When the jumper is set, the condition (on/off) of the corresponding

power output is switched. Additionally the outputs may be switched via

the PC-software if the multiswitch™ is connected via USB (not possible if

connected as an aquabus-device).

With an open jumper setting the buttons have no direct influence on the

outputs of the multiswitch™ and are only interpreted via the PC-software

when connected as an USB-device.

If the power outputs of the multiswitch™, when connected as an

aquabus-device to the aquaero, should be switched, the jumper must be

open!

Jumper open:

Jumper closed:

Jumper position 5: USB/aquabus

This jumper configures which interface of the multiswitch is active.

Jumper open:

Jumper closed:

- 10 -

before you activate this function. Failure to do so

before

PWM activated

PWM deactivated

Interpret buttons only via the PC-software

Buttons switch power outputs directly

USB enabled, aquabus disabled

aquabus enabled, USB disabled

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen

Failure to do so