Aqua Computer aquabus X4 사용자 및 설치 설명서

{카테고리_이름} Aqua Computer aquabus X4에 대한 사용자 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Computer aquabus X4 3 페이지.

aqua

computer

User and installation manual

Description

Active quadruple aquabus splitter.

For operation, an aquaero 5 or aquaero 6 device with firmware version 2100 or

higher is required. Compatible firmware versions are included starting with aqua-

suite version 2018-1.

Installation onto an aquaero 5/6

The aquabus X4 is to be installed directly on top of an aquaero 5/6 device:

1. Turn off the PC, disconnect the aquaero from the PSU, disconnect the USB

cable, the standby power cable (aquaero 5 only) and aquabus high speed

cable from the aquaero if connected.

2. Remove the two screws adjacent to the temperature sensor inputs and to the

speed signal output from the aquaero.

3. Plug the aquabus X4 module onto the aquabus high speed connector of the

aquaero.

4. Secure both PCBs using the two cylindrical spacers and screws according to

the following figure. (The aquabus X4 can also be installed if a passive heat

sink is installed on the aquaero, in this case use the shorter spacers supplied

with the heat sink, replacement part number 91239.)

5. Connect aquabus high speed compatible devices to the aquabus connectors

of the aquabus X4 module. Reconnect PSU, USB and standby cables to the

corresponding connectors (if previously installed) and start the PC.

aquabus X4

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen

aquabus X4

94716