Aqua Cooler Maximus XMCC 사용 및 관리 매뉴얼 - 페이지 4

{카테고리_이름} Aqua Cooler Maximus XMCC에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Cooler Maximus XMCC 9 페이지.

UNPACKING THE WATER COOLER

After unpacking the water cooler, wipe with a soft cloth.

Place the machine on a hard, flat surface. Make certain the unit is level. The unit should not be close to

direct sunlight or other sources of heat.

It is best to place the water cooler in an area with good air circulation. Make sure there is at least 10 cm

of space between the back of your cooler and the wall. Keep a minimum distance of 5 cm on each side of

your water cooler.

WARNING - The drain cap on the back of the unit may become loose during shipping. Fasten the drain

cap tightly before you start to operate the unit. If the drain cap is loose, the unit may leak and cause

floor damage.

INSTALLATION PROCEDURE

Make sure the water dispenser is not plugged into an electrical outlet.

Attach the mains water connection to the rear of the cooler.

Press either of the water taps down until water begins to flow then let go.

Insert the power plug into an electrical outlet.

For the cook and cold model: Switch the cold water switch to the ON position.

After the cooler has been connected to the water cooler, the unit is ready for use. Water will flow from the bottle

into the cold reservoir, and then the unit's compressor will start to operate. The first time the water cooler is

used, you will have to wait at least 45 minutes for cold water.

For the cook and cold model:

• To dispense cook (ambient) water, press the cook tap down.

• To dispense cold water, press the cold tap down.

Your Partner in Cool.