AAXA Technologies M1 Ultimate 사용자 설명서 - 페이지 16

{카테고리_이름} AAXA Technologies M1 Ultimate에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AAXA Technologies M1 Ultimate 18 페이지.

Troubleshooting

Possible Causes

There is no power

The projector is in the shut-down cooling cycle

NO PICTURE

Possible Causes

The video source is not properly connected

The correct input source has not been selected

IMAGE IS BLURRED

Possible Causes

The Projector is not in focus

The Projector is offset from plane / angle of

operation

SD CARD IS NOT RECOGNIZED

Possible Causes

SD Card is not inserted properly

SD Card is damaged

Possible Causes

The remote control battery is dead

Check to ensure the power outlet or battery source is good. Check

the power adapter to ensure a proper connection with the wall

outlet as well as the projector.

Wait until the projector has fully cooled to restart

Solution

Check the video source signal to ensure that it is properly

connected

Select the correct input source by pressing the Source key on the

remote.

Adjust the focus with the focus adjustment dial until the image

comes into focus

Move the projector so that it is at both 180 degrees and on an

even plane with the screen. Please see Page 9

Re-insert SD Card

Replace SD Card

Replace the battery with comparable CR2025 battery

Solution