Aqua Cooler AC-P8EBFTY-ASM 사용 및 관리 매뉴얼 - 페이지 5

{카테고리_이름} Aqua Cooler AC-P8EBFTY-ASM에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Cooler AC-P8EBFTY-ASM 11 페이지.

INSTALLATION CONT.

Using the 38" piece of tubing provided, cut 6" and install it on the end of the TEE. Install the

remaining tubing onto the branch of the TEE. Connect the other end of the TEE to the tank

outlet tubing (tube that was disconnected from the elbow).

Route the TEE and tubing under the waste drain and connect the 6" length to the water valve

elbow.

Feed black and blue tubing up through bushing in top. For single unit, also feed white tube

attached to tee through bushing. Attach top to cooler. If flow switch was installed, cord from

flow switch must also pass through this bushing.

INSTALLATION C: Mounting the frame to the wall.

Place rubber gasket on top of the cooler so it is centred left/right and against the wall.

Set the wall frame onto the gasket. Centre it left/right and push it against the wall and mark hole

locations for wall fasteners. The gasket will set the frame at the proper height.

Secure frame to the wall with fasteners (not provided). Pull plastic tubing up through the hole in

the frame.

Your Partner in Cool.

INSTALLATION CONT.

Slide sponge tubing insulation over water line. Connect the tubing to the INLET of the solenoid

on the back of the Hands-free VersaFiller assembly and (optional) flow switch connector into port

on circuit board.

Install bottle filler tether with the steps below.

The tether keeps the bottle filler secured to the frame when changing the filter, if installed. Make

sure the tether is installed properly to avoid accidental damage to the unit.