A.caminetti 4D 사용 설명서 및 설치 - 페이지 6

{카테고리_이름} A.caminetti 4D에 대한 사용 설명서 및 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. A.caminetti 4D 11 페이지.

FLANGE POSITIONING

For connecting the flange with the main body follow the steps as in photos below.

Remove first the metalic circle of the main body as in (fig.1b).Place easily the connection

flange which is packaged inside the fire body (fig.1c).Place the screws than in the side spaces,

to fix the flange on the body as in (fig.1d).Finally set the matalic circle on its first position (fig.1e).

(fig.1a)

FUEL CHOICE

Recommended Fuel

- the manufacturer recommends hardwood billets like beech, hornbeam, oak,

alder, birch, ash,etc., with billet or split log dimensions 30cm long and

circumferences between 30 and 50cm,and lignite briquettes.

- the humidity of the fuel wood for the appliance should not exceed 20%.

Not Recommended Fuel

You should avoid burning billets of split logs with a humidity of over 20% as it can

prevent theapplian- ce from achieving its declared technical specifications, and can

reduce the heat output.Burning softwood billets and high-resin wood in the

appliance is not recommended, as they result inheavy smoking and frequent

cleaning of the appliance and chimney flue.

The following is not allowed to be burned in the heaters: minerals, e.g. coal, tropical wood (like

maho- gany), chemical products and fluids, (like oil, alcohol, petrol, and naphthalene),

laminated boards, or adhesive-bonded, impregnated or pressed wood chips and litter. If any

other fuel is allowed, it will be notified on the rating plate.

Avoid filling the hearth with wood fully, optimising the amount of fuel at one-third of thecombustion

chamber's capacity.

(fig.1b)

(fig.1c)

(fig.1d)

(fig.1e)