Dexter Laundry DDAD T-30 2 Series 문제 해결, 결함 코드 및 회로도 - 페이지 2
{카테고리_이름} Dexter Laundry DDAD T-30 2 Series에 대한 문제 해결, 결함 코드 및 회로도을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry DDAD T-30 2 Series 8 페이지. 30 pound stacked commercial dryer
페이지 인쇄
Trouble Shooting
Electronic Control Diagnostic Lights
The electronic control has 6 diagnostic lights to aid in service of the dryer. Each pocket has indicator
lights for the motor circuit, door switch circuit, and the heat circuit. When the electronic control is carefully
unlocked and moved forward these lights are visible on the circuit board. They are each labeled as to
function indicated.
1. When either dryer door is closed, the appropriate door light on the computer should be illuminated
indicating that the door is closed.
2. When either dryer is running, the appropriate motor light on the computer should be illuminated
indicating that the computer is calling for the motor to operate.
3. When either dryer is calling for heat, the appropriate heat light on the computer should be
illuminated indicating that the computer is calling for heat.
An example of their function would be troubleshooting an upper dryer pocket that did not heat.
1. Start the machine and insure that it did not heat.
2. Check the upper heat light and see if it is lit.
3. If the heat light is on, this would indicate that the computer was calling for heat and that it was not
at fault. You would then go on to check the rest of the heat circuit.
Electronic Control Test Cycle
This test cycle allows the dryer to run for 5 minutes without the need for adding money while servicing. To
actuate this 5 minute test cycle leave the loading doors closed, unlock the computer and push the program
button on the right front corner of the computer as if you were putting it into the program mode. This will
give a 5 minute cycle on both tumblers for evaluating the machine.
2
Part # 8533-061-001 11/13