AVLink 128.303UK 사용자 설명서
{카테고리_이름} AVLink 128.303UK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVLink 128.303UK 2 페이지. 2:4 audio management speaker selector
페이지 인쇄This matrix switcher for stereo amplifiers has 2 inputs and 4 outputs. Any of the inputs may be routed to any
of the outputs, or the same input may be routed to all outputs or any combination. Simply connect the output
of the amplifiers to the inputs, these inputs can then be routed to four different stereo speaker sets in four
different locations, each speaker set can be individually activated via the push buttons on the front of the box
and individual volume controls.
Features:
•
Enables four pairs of speakers to be
connected to two separate amplifiers.
•
Heavy-duty push buttons.
•
Built-in overload protection.
•
Designed for 4-16 ohms speakers.
Installation consideration:
The AD-SPK2:4 is designed for use with an amplifier with a maximum power of 180 Watts per channel at 8
ohms respectively. If you are uncertain about the power rating of your amplifier, consult the appliance's
manufacturer.
It is recommended to use only 8-ohm speakers when using the AD-SPK2:4. We do not recommend installing
more than 1 pair of speakers per pair of channels. Each pair of channels or terminal block is designed for 1
pair of speakers using up to 14-gauge wire.
Speaker wires can act as an antenna for electrical noise. Locating speaker wires too close to light dimmers or
switches may cause a buzzing or popping sound to be heard through the speakers. If you must locate the AD-
SPK2:4 wiring near electrical devices, route the speaker wires several inches away.
Installation:
•
Insert each wire into the appropriate hole on the
removable terminals.
•
Strip ¼" of insulation from the end of each wire and
tightly twist the ends until no frayed ends remain.
Use a small screwdriver to tighten each wire in place.
•
Insert the connector plug into the socket and lock in
place by tightening captive screws on the side of
each connector. The inputs of AD-SPK2:4 are the
connecting terminals for the amplifiers. Be sure not
to reverse these connections or the AD-SPK2:4 will
not function properly.
•
Each zone gets connected to a pair of speakers.
Make sure you connect negative (-) to negative (-)
and positive (+) to positive (+).
www.avsl.com
2:4 Audio Management Speaker Selector
•
Black aluminium housing.
•
Individual volume controls with black
aluminium finish.
•
Accepts up to 14-gauge speaker cable.
•
Individual A/B switch per zone.
Item ref: 128.303UK
User Manual
128.303UK User Manual