Dexter Laundry 400 EXPRESS 소유자 책자 - 페이지 12

{카테고리_이름} Dexter Laundry 400 EXPRESS에 대한 소유자 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry 400 EXPRESS 13 페이지. 25lb capacity computer control coin-op washer installation & operation instructions

페이지 인쇄

Delay Fill "dF"

Spin Time "S"

"IS"

COIN WASHER DEFAULT CYCLE

The following table shows the complete details for the coin washer default cycle.

Bath

Bath Cycle

Time

(min.)

Prewash

Wash

Rinse 1

Rinse 2

Final

Rinse

Note *

Rapid Advance Mode

To enter the Rapid Advance mode, push and hold the Cold water temperature button and then

push the programming button on the controller. There will be no observed change to the washer

or the display. The Rapid Advance mode can be entered from either the Idle mode or during the

cycle. To rapid advance to the next step in the wash cycle, push both warm temperature buttons

at the same time. The display will show an "Ad" (advance) in the display. The washer will

advance to the next bath segment. The water will drain before the advance will occur.

The Rapid Advance mode will not end until the final bath segment is completed. The final

segment cannot be skipped in Rapid Advance mode.

Notes: 1. When the Rapid Advance mode is used, the cycle time will no longer be correct.

2. By skipping steps with rapid advance, the door may not open immediately at the end

of the cycle.

The selections are "d" for delay the bath time until water

level is reached or "t" for decrement bath time during the

fill.

0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse2

1 to 10 minutes for Final Spin.

The owner can change the displayed value, but for a coin

washer only 0 will be put into the cycle.

Water

Temp.

These default values are preset and cannot be changed.

Water

Delay Fill

Level *

Spin Time

IS *

(min.)