Aqua Creek F-004PPPB-AT1 설치 및 운영 지침 매뉴얼 - 페이지 15

{카테고리_이름} Aqua Creek F-004PPPB-AT1에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek F-004PPPB-AT1 20 페이지.

If the battery is fully charged and the lift is not moving then:

2. Check all cords:

A. Check that the cords are properly plugged in. Start by unplugging the

remote and the actuator cord from the control box. Once these cords

are removed check the ends for corrosion or damage. Plug the remote

cord back in by lining up the raised tab on the plug to the grooved line

on the control box outlet. Note that these cords require some force to

plug them in fully. You will know they a correctly inserted when you

here a "popping sound". The cords will be recessed into the outlet. If

they are flush with the outside of the outlet they are not plugged in

fully and the lift will not function. Make sure you do this for both

cords.

NOT inserted fully.

If you have checked all the cords and the lift still doesn't move:

3. Check the contact points:

A. After you have fully charged the battery and checked the cords to

make sure they are properly plugged in, check to make sure the contact

points are not corroded or bent. If the contact points are corroded take

some rubbing alcohol and a q-tip and clean off the points. After

cleaning the contact points it is recommended to put some dielectric

grease on the contact points (terminals) to help ensure good electrical

contact and prevent corrosion. Then reinstall the battery on top of the

control box. Make sure you hear a "click", which indicates that the

battery is correctly seated. The lift will not work if the battery is not

seated correctly.

Silver tabs are the contact

(terminal) points.

Fully inserted.