Aqua Creek F-PPXRD-NA-03 매뉴얼 - 페이지 7

{카테고리_이름} Aqua Creek F-PPXRD-NA-03에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek F-PPXRD-NA-03 14 페이지.

페이지 인쇄

Anchor Installation: New Construction

You will need:

• Tape measure

• Marking pen

• Torpedo level

• Large adjustable wrench

• Concrete & concrete

fi nishing tools

• #5 rebar

51"

10"

51"

10"

*SETBACK DISTANCES ARE

FOR FLAT DECKS. IF YOUR

DECK IS SLOPPED, CONTACT

AQUA CREEK BEFORE

INSTALLATION.

29"

2500PSI

MIN

#5 REBAR

FIGURE 6

6. Pour your concrete and fi nish the pool deck surface.

7. Once the concrete has cured the lift is ready to be mounted to the anchoring system.

NOTE: For installations where a new deck is being poured, or where a

dedicated pad is being poured just for the pool lift, the concrete must

satisfy the ADA requirements outlined on page 3 of this manual.

Your pool deck must be at least 4 feet - 3 inches long by 4 feet - 3

inches wide by 6 inches thick. It must be reinforced with 5 sticks of

#5 rebar each way, 2 inches clear (min) from the top and bottom of

the footing.

POOL DECK

*22 1/2" MIN

38" MAX

22"

"GATOR HAUNCH"

*22 1/2" MIN

38" MAX

1. Remove one nut from each anchor

insert. Place the anchor inserts through

the larger hole of the anchor jig plate.

Thread the removed nuts back onto the

anchor inserts. The anchor plate should

be sandwiched between the two nuts

on each anchor insert.

SEE FIGURE 4, PAGE 6

2. Install rebar in the open area of the

deck.

SEE FIGURE 5, PAGE 6

3. Set the anchor system in place. For

ADA compliance and clearance, make

sure the center of the large anchor jig

plate holes are between 22.5 and 38

inches from the pool's edge.

FLORIDA

4. Using the string line or a straight

edge & level, confi rm the top of each

anchor body is level with the FINISHED

deck surface. Each anchor body can be

individually adjusted by turning the

nuts with a large wrench.

5. Bond the anchoring system by using

the bonding lug on the anchor jig plate.

Bond the system according to your

local code requirements.

680.26) SEE FIGURE 5, PAGE 6

SEE FIGURE 6

(See NEC Article

Revised 6/17/19