Aqua Creek PRO SPA 60 매뉴얼 - 페이지 3

{카테고리_이름} Aqua Creek PRO SPA 60에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek PRO SPA 60 17 페이지.

PRO SPA 60 ASSEMBLY

1. Remove tie-wraps and bubble packing from electric actuator.

2. Slide the chair arm up until the actuator bracket is about even with the actuator lug.

3. Align the holes in the actuator lug with the hole in the actuator bracket. Attach the

actuator to the actuator bracket using one (1) 3/8" x 1-1/4" shoulder bolt, one (1) 5/16"

flat washer and one (1) 5/16" nylock nut as shown in FIGURE 1. Tighten the nut until

snug.

PRO SPA 60 WIRING: Y-CONNECTOR

The Pro Spa 60 uses two electric actuators

to lift the seat and these actuators are

wired together using a special y-connector.

The y-connector is plugged into channel 1

of the control box.

When operating properly both electric

actuators will move at the same time. If

only one actuator moves at a time there

may be a problem with the y-connector or

the electric actuator. Always make sure the

plugs are fully seated in the control box.