Aqua Creek F-700RL 매뉴얼 - 페이지 4

{카테고리_이름} Aqua Creek F-700RL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek F-700RL 14 페이지.

페이지 인쇄

Anchor Installation: New Construction or Retro-Fit

You may need to saw cut and remove a portion of an existing pool deck in order to achieve the 10 inch depth

footing requirement. Aqua Creek does NOT recommend a core drill installation for this lift.

To properly install this anchor, you will need to have a concrete footing comprised of 4500 psi concrete that is

10 inches deep and 4 feet - 3 inches square and reinforced with rebar. Refer to Figures A and B below.

If cutting into an existing pool deck, the rebar must be drilled and secured to the surrounding pool deck on

three sides (do not secure into bond beam). The centerline of the anchor should be no less than 9 inches from

the edge of the footing.

NOTE: The anchor setback will vary depending on application and any options you choose for the lift. 16

inch setback is the minimum for ADA compliance however, given a typical 1 foot bond beam and the fact that

the anchor should be no closer than 9 inches to the edge of your footing, 21 inches may be the closest you

can achieve. The chart below outlines the minimum and maximum anchor setback locations for the available

options based on this premise. Also, some attachments will de-rate the lifting capacity of the lift. Refer to the

attachment manual or spec sheet to check for changes in lifting capacites.

1. Determine the location for the anchor based on the options you are ordering or think you may order in the

future and set the anchor in place. You may use a small mass of wet concrete to set the anchor in place.

Use a level and string lines to make sure the anchor is perpendicular and will be fl ush with the top of the

fi nished deck surface.

2. Bond the anchor according to local code requirements using the bonding lug on the bottom of the anchor.

Reference the National Electric Code (NEC) Article 680.26 for specifi cs on bonding.

3. Pour the concrete so that the top of the anchor will be fl ush with the FINISHED pool deck surface.

4. Once the concrete has cured, the lift can be put into place.

FIXING

ANCHOR

4'-3"

LOCKING-PIN

2'-1

2 "

4'-3" SQ. x 10" DEEP

CONC. FTG. W/4 - #5

E.W., TOP & BTM. &

#4 U BAR @ TOP

(SEE FIGURE B)

EPOXY TOP MATT

TO EXISTING SLAB

10"

(4" MIN. EMBED)

ITEM NO.

F-730RSA-S2

F-706RLSS

4'-3"

1'-0"

MIN.

MIN

2 "

SLOT

FIXING

REVOLUTION

ANCHOR

BRONZE ANCHOR

SLEEVE

4'-3"

CLR

FIGURE A

CLR

F-734RSA

F-705-S2

WHEELCHAIR ADAPTER

2'-0"

POOL

WALL

1'-9" MIN.

3'-0" MAX.

DECK

OPTION

GURNEY

SLING SEAT

SPINE BOARD

1'-0"

MIN

MAX

21"

32"

21"

24"

21"

34"

21"

34"

Revised 8/11/16

FIGURE B