A.H. Systems 2383 운영 매뉴얼 - 페이지 10

{카테고리_이름} A.H. Systems 2383에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A.H. Systems 2383 15 페이지. Active loop antenna

A.H. Systems Model SAS-562B Active Loop Antenna

CHARGING THE BATTERY

Plug the battery charger into either 110

50 Hz. The amplifier ON-OFF switch must be in the OFF/CHARGE position to

charge the battery. Connect the other end of the charger to the charging port

of the amplifier. The charger should now be on and charging the battery. The

indicator light should be red. The red charge light will stay on until the battery

is about 95% recharged. At this point the indicator will turn green and the

battery may be used. The battery should be left connected to the charger for

an additional three hours to ensure a 100% recharge. To ensure a full charge

and to help your battery keep its full capacity, we recommend that the battery

be left connected to the charger, in float charge mode, until ready to use. The

battery may be left connected to the charger indefinitely, in float charge mode,

without danger of overcharging. Using the battery charger to operate the

amplifier directly is not recommended.

REPLACING THE BATTERIES

Remove the four 6-32 flat head screws from the bottom of the base unit.

Disconnect the battery lead from the PC card. Re-connect the lead from the

new battery pack to the PC card. Snug the four 6-32 flat head screws.

 A.H. Systems inc. – Oct 2014

REV B

120 Vac, 60 Hz or 220

–

240 Vac,

–